Whats the deal with memory management in NX?
Whats the deal with memory management in NX?
(OP)
Currently using NX4 but have always noticed this problem. Doing renderings in particular is where it is the worst. Basically NX starts allocating memory as it performs a task. The more complex the task, the more memory is used of course. But when the task is completed the memory is not dumped. So I can do a rendering on a part that takes 3 minutes, then do another and another, and by the time I'm on say the 5th rendering it takes 10+ minutes.





RE: Whats the deal with memory management in NX?
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.