Align views
Align views
(OP)
I use align view overlay point to point to overlay two drafting views on top of each other. This works well, but if I want to move both of the views I have to remember to pre-select both views before dragging to a new location (when the views are overlayed it is not clear that there are two views, it looks like just one). Is there a way to pre-select and move one view and the other view will automatically move with it?
Also if I change the model the two views may not still be aligned after updating the views. I would like the views to automatically re-align them selves if things change.
Regards
Also if I change the model the two views may not still be aligned after updating the views. I would like the views to automatically re-align them selves if things change.
Regards
NX 7.0.1.7, TC 8.1





RE: Align views
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.