Making a whole part a shell
Making a whole part a shell
(OP)
Is there a way to make a whole completed part into a shell with every surface the same thickness. I am trying to create a bucket with extrusions on the base, and all the extrusions are hollow, like the whole part was made in a press.
I can upload what I am talking about if this is confusing.
Thanks
I can upload what I am talking about if this is confusing.
Thanks






RE: Making a whole part a shell
RE: Making a whole part a shell
Jeff Mowry
www.industrialdesignhaus.com
A people governed by fear cannot value freedom.