NX6 DATUM PLANE SHADE
NX6 DATUM PLANE SHADE
(OP)
Hi friends
I have a problem with NX6, when I create a new model, I need to create many datum planes too. The problems is when I "turn on" many of them, the visibility of the principal part is to poor (see attch. photo).
Some of you knows how to eliminate the "shade" in datum plane?.
Probably user of NX3 to NX6 understand this situation.
Thanks for your attention and help.
Tom
I have a problem with NX6, when I create a new model, I need to create many datum planes too. The problems is when I "turn on" many of them, the visibility of the principal part is to poor (see attch. photo).
Some of you knows how to eliminate the "shade" in datum plane?.
Probably user of NX3 to NX6 understand this situation.
Thanks for your attention and help.
Tom





RE: NX6 DATUM PLANE SHADE
RE: NX6 DATUM PLANE SHADE
Thank a lot for your help, your comment was correct.
Best regards.
Tom
RE: NX6 DATUM PLANE SHADE
Best Regards
Hudson
www.jamb.com.au
Nil Desperandum illegitimi non carborundum
RE: NX6 DATUM PLANE SHADE
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: NX6 DATUM PLANE SHADE
Best Regards
Hudson
www.jamb.com.au
Nil Desperandum illegitimi non carborundum