Help with the tool body trim
Help with the tool body trim
(OP)
Hello good day.
As it is I hope and I can help with the following query
E NX6 been working with. Modeling a piece through surfaces (plates)
But the problem arises when I try to cut one sheet against another
When I apply the body trim tool send me the error (HAART Do Not intersect.
Edit or Targed the tool to completely intersect.)
What could be.
I have attached a picture of model
Regards
As it is I hope and I can help with the following query
E NX6 been working with. Modeling a piece through surfaces (plates)
But the problem arises when I try to cut one sheet against another
When I apply the body trim tool send me the error (HAART Do Not intersect.
Edit or Targed the tool to completely intersect.)
What could be.
I have attached a picture of model
Regards





RE: Help with the tool body trim
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.