Send To...
Send To...
(OP)
Hi All,
I have a fairly large assembly that contains quite a few sub-assemblies. I would like to, if possible, do a "send to" that allows me to select only a few of the sub-assemblies.
Is there any way that I can select the subassemlies to send and have the system automatically select all of the parts that reside in the assemblies that I have selected?
I can't seem to figure this out. Am I ignoring something obvious?
Thanks in advance
thixoguy
I have a fairly large assembly that contains quite a few sub-assemblies. I would like to, if possible, do a "send to" that allows me to select only a few of the sub-assemblies.
Is there any way that I can select the subassemlies to send and have the system automatically select all of the parts that reside in the assemblies that I have selected?
I can't seem to figure this out. Am I ignoring something obvious?
Thanks in advance
thixoguy





RE: Send To...
Regards
Fernando
RE: Send To...
Buuuut............. embarrassingly enough, I have never worked with catscripts, ever.
I suppose I will have to look into this.
thixoguy
RE: Send To...
Regards
Fernando
RE: Send To...
Thanks very much for the great little presentation
thixoguy