Goodbye everyone
Goodbye everyone
(OP)
Hi all,
in the past few years I have used this forum on a regular basis to enhance my knowledge of Solid Edge. I have tried to help others when I could, but must admit that hasn't been the case wuite often enough.
Now I have to leave this forum, as I no longer use Solid Edge. I have switched jobs, I am now an Application Controller for Solid Works, SmarTeam and Trimergo (CAD/PDM/ERP).
I will not be using Solid Works, so I cannot compare the two programs. I do think however that you guys use remarkebly well engineered CAD-software.
Goodbye,
IJsbrand Schipperus (find me on linkedin if you like)
in the past few years I have used this forum on a regular basis to enhance my knowledge of Solid Edge. I have tried to help others when I could, but must admit that hasn't been the case wuite often enough.
Now I have to leave this forum, as I no longer use Solid Edge. I have switched jobs, I am now an Application Controller for Solid Works, SmarTeam and Trimergo (CAD/PDM/ERP).
I will not be using Solid Works, so I cannot compare the two programs. I do think however that you guys use remarkebly well engineered CAD-software.
Goodbye,
IJsbrand Schipperus (find me on linkedin if you like)
Visualise your vision... in 3D
www.Horchner-Hammersma.nl





RE: Goodbye everyone
bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.
Where would we be without sat-nav?
RE: Goodbye everyone
Kyle
RE: Goodbye everyone
What is Engineering anyway: FAQ1088-1484: In layman terms, what is "engineering"?