Hole/point on exterior cylindrical surface
Hole/point on exterior cylindrical surface
(OP)
Is it not possible to place a hole/point on the face of an exterior cylindrical surface at the intersection of two planes? See attached.
I'm attempting to put a hole/point on surface 1 where datum 1 and 2 intersect it. I understand there are two possible locations that would be defined. I'll take either one at this stage of the game.
I'm attempting to put a hole/point on surface 1 where datum 1 and 2 intersect it. I understand there are two possible locations that would be defined. I'll take either one at this stage of the game.
--
Fighter Pilot
Manufacturing Engineer





RE: Hole/point on exterior cylindrical surface
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.