ss plasma
ss plasma
(OP)
We using a plasma table to cut SS 304 plate of 1/2" to 1" thickness, and are noticing relatively signifacant warpage.
Is this inevitable or does anyone have any recomondations on how to limit this warpage?
Is this inevitable or does anyone have any recomondations on how to limit this warpage?





RE: ss plasma
That will eliminate the warpage.
... and make a whole new kind of mess. You'll have to dispose of wet burned metal muck instead of dry burned metal dust.
Mike Halloran
Pembroke Pines, FL, USA
RE: ss plasma
RE: ss plasma
Add some.
Mike Halloran
Pembroke Pines, FL, USA
RE: ss plasma
RE: ss plasma
It will also produce clouds of steam, and spray water and sludge around, and occasionally screw up your cutter nozzle,
but it will prevent distortion.
Or you can leave the water level down where the cutter is not such a housekeeping problem, and deal with the distortion some other way.
Mike Halloran
Pembroke Pines, FL, USA
RE: ss plasma