How to Change Step Value Globally
How to Change Step Value Globally
(OP)
When placing a line, point, etc. I like to use the up and down arrows to increment the distance values. In Catia, it is set to 1 inch which is too big for the work I do. I can change the step value, but it defaults back to 1 inch. Can I set it to 1/32 inch and make it stay 1/32 inch? See attached screenshot.
Mark





RE: How to Change Step Value Globally
RE: How to Change Step Value Globally
Mark
RE: How to Change Step Value Globally
Regards,
Derek
RE: How to Change Step Value Globally
Mark