Part shows as hidden in .SLDDRW but is shown in .SLDASM
Part shows as hidden in .SLDDRW but is shown in .SLDASM
(OP)
For some strange reason I have a part in a drawing file hidden. You can see in the FeatureManager Design tree the part is grayed out. I tried "right clicking" on it to see if I can unhide it. But I'm not getting that option.
If I go to the part file or assembly file you can see it.
Anyone have this problem? It's just this one part.
If I go to the part file or assembly file you can see it.
Anyone have this problem? It's just this one part.






RE: Part shows as hidden in .SLDDRW but is shown in .SLDASM
Are you right-clicking in the drawing FM or model FM?
RE: Part shows as hidden in .SLDDRW but is shown in .SLDASM