Sub-assembly constraints
Sub-assembly constraints
(OP)
Hi,
in NX3, when selecting a component of sub-assembly in the graphic area, the mating condition mask show only the mating of that sub-assembly, with NX7 I see that all constrains of that sub-assembly.
How can I see only the sub-assembly mates when I select a sub-component in the graphic area ?
Regrads
in NX3, when selecting a component of sub-assembly in the graphic area, the mating condition mask show only the mating of that sub-assembly, with NX7 I see that all constrains of that sub-assembly.
How can I see only the sub-assembly mates when I select a sub-component in the graphic area ?
Regrads





RE: Sub-assembly constraints
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Sub-assembly constraints
I attach an image to better understand.
RE: Sub-assembly constraints
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.