Anyone have experience with OKUMA internal grinders?
Anyone have experience with OKUMA internal grinders?
(OP)
Hi all,
Like the subject says, anyone have experience with OKUMA internal grinders? GI-20N to be exact.
Specifically, I need to get the workhead spindle to go "neutral". I cannot figure out how to do that.
We need to indicate some gears over pins and the task is nearly impossible without turning the spindle by hand in neutral.
I know, this may not be the best fourm for this post, but there are a few people on here who are clearly "in the know" in manufacturing, so, there it is.
Thanks,
Jay
Like the subject says, anyone have experience with OKUMA internal grinders? GI-20N to be exact.
Specifically, I need to get the workhead spindle to go "neutral". I cannot figure out how to do that.
We need to indicate some gears over pins and the task is nearly impossible without turning the spindle by hand in neutral.
I know, this may not be the best fourm for this post, but there are a few people on here who are clearly "in the know" in manufacturing, so, there it is.
Thanks,
Jay




