Offsets
Offsets
(OP)
When placing a member in STAAD, it places it centerline to centerline (using W-shapes). I know that you can place offsets by using the specification page...beam...offsets.
My question is, is there a more simple way to place offsets without having to select each end of each member??
My question is, is there a more simple way to place offsets without having to select each end of each member??





RE: Offsets
RE: Offsets
I was told there was a command that could be used to offset but they don't remember what it is.
RE: Offsets
RE: Offsets
RE: Offsets