post builder MOM variable needed
post builder MOM variable needed
(OP)
Hi Guys,
I need a MOM variable for Cutter compesantion on postbuilder.
I tried to find it but I'm young learner on postbuilder.
Thanks.
I need a MOM variable for Cutter compesantion on postbuilder.
I tried to find it but I'm young learner on postbuilder.
Thanks.





RE: post builder MOM variable needed
If you edit the D word, you should also see some common variables that are used.
Mark Rief
Product Manager
Siemens PLM
RE: post builder MOM variable needed
RE: post builder MOM variable needed
these are some examples that you can use for milling
radius compensation for reminding us that have to assemble the variable
correctly but of error
or go to post builder please browse utilies variables enter cutcom
will show a list of all possible options
but these are below are the main
mom_cutcom_mode
mom_sys_cutcom_code(LEFT)
mom_sys_cutcom_code(ON)
mom_sys_cutcom_code(RIGHT)
mom_sys_cutcom_status
goes this way on the block
$mom_sys_cutcom_code($mom_cutcom_status)
hug...
Andre....
specialist and multi axis
development of IS & V
and postprocessors
member committee nxcam plm world