?? modified
?? modified
(OP)
not so serious but...
Nx7.01mp1 drafting save your work, pre select a centerline and the part gets a modified flag :)
Nx7.01mp1 drafting save your work, pre select a centerline and the part gets a modified flag :)





RE: ?? modified
However, when I tested NX 7.5 it does not, so at this point a PR would be pointless since, as you stated, it's "not so serious" and it's appears to have already been fixed.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: ?? modified
... it appears in Nx6.05,too
thx John
... not so serious but annoying
RE: ?? modified
Best regards,
Michäël.
NX4.0.4.2 MP10 / TCE 9.1.3.8_build_0711 / NX6.0.2.8 / NX7.0.0.9
Belgium
RE: ?? modified
I know that there has been an ongoing effort to investigate the situations which trigger the 'modified' notice. The goal was to determine when and if they were legitimate as we had discovered over the years that they often were not. It would appear that this effort is starting to pay-off.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.