NX6- mating
NX6- mating
(OP)
Have a lot to learn to move from NX2 to NX6. Here comes the mating. Center. I can't find 1 to 1 sub type. Is there something wrong with the set up? thx
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS Come Join Us!Are you an
Engineering professional? Join Eng-Tips Forums!
*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail. Posting GuidelinesJobs |
|
RE: NX6- mating
RE: NX6- mating
But isn't the "center" supposed to do the work? I looked up the documentation. it tells me there is a subtupe called "1 to 1". Just couldn't find it.
RE: NX6- mating
1-1
2-1
1-2
However, for most 1-1 alignments you don't need to bother with centre. Use "touch align" and touch-align the hole axes.
These appear as centre lines if you hover on the curved surfaces.
I've used both systems and whilst the old mating conditions was pretty good, I'd say that the new system is better.