NX 6 - Holes
NX 6 - Holes
(OP)
NX 6.0.5.3
Not sure how I didn't notice before, but what happens to the 'p'named expressions ?
Create a Block and add a Counterbored Hole and I end up with ...
p6
p7
p8
p48
p49
p53
p57
p60
p119
p120
Where did all the in-between 'p' named expressions go ?
Not sure how I didn't notice before, but what happens to the 'p'named expressions ?
Create a Block and add a Counterbored Hole and I end up with ...
p6
p7
p8
p48
p49
p53
p57
p60
p119
p120
Where did all the in-between 'p' named expressions go ?
Specialty Engineered Automation (SEA)
http://www.sea4ug.com
a Siemens PLM Solutions Partner





RE: NX 6 - Holes
I don't know if you can control this behavior, but i recall there was a post on the forum with a grip program that changed the parameters. Maybey you can search for it.
Best regards,
Michäël.
NX4.0.4.2 MP10 / TCE 9.1.3.8_build_0711 / NX6.0.2.8 / NX7.0.0.9
Belgium
RE: NX 6 - Holes
Best Regards
Hudson
www.jamb.com.au
Nil Desperandum illegitimi non carborundum
RE: NX 6 - Holes
Maybey you can adapt it?
Best regards,
Michäël.
NX4.0.4.2 MP10 / TCE 9.1.3.8_build_0711 / NX6.0.2.8 / NX7.0.0.9
Belgium
RE: NX 6 - Holes
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: NX 6 - Holes
Noticable it most certainly is !!!
I was looking at a relatively simple model, with not so many Holes, and noticed the expressions were beyond the p3500 count.
I wondered how on earth the guy had had so many attempts at the model. Turns out, he actually hadn't
Specialty Engineered Automation (SEA)
http://www.sea4ug.com
a Siemens PLM Solutions Partner