Creating an envelope part
Creating an envelope part
(OP)
As I see it, the only way to create an envelope part of something I already have is to: /Insert/envelope/from file.
I sometimes have to insert numerous envelope parts that are the same and it's not possible to insert x number of parts at one go. I have to keep going through the same loop.
The most intuitive way of creating an envelope part in an assembly would be to perhaps right click on the relevant part (or assembly), select 'create envelope part' and away you go! But I can't. It seems the only way is through the slow tedious route described above.
Am I missing something??
I sometimes have to insert numerous envelope parts that are the same and it's not possible to insert x number of parts at one go. I have to keep going through the same loop.
The most intuitive way of creating an envelope part in an assembly would be to perhaps right click on the relevant part (or assembly), select 'create envelope part' and away you go! But I can't. It seems the only way is through the slow tedious route described above.
Am I missing something??






RE: Creating an envelope part
Could this be a worthy entry for a new feature request? Or maybe I'm the only one who finds this irritating!
RE: Creating an envelope part
Deepak Gupta
SW2009 SP4.1
SW2007 SP5.0
MathCAD 14.0