Open NX6 simulation in NX5?
Open NX6 simulation in NX5?
(OP)
I have one simulation done with NX6 and I'm now running NX5.
Is there any way I can open this in NX5?
I do not have access to NX6 for saving in older versions.
BR
Anders
Is there any way I can open this in NX5?
I do not have access to NX6 for saving in older versions.
BR
Anders





RE: Open NX6 simulation in NX5?
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Open NX6 simulation in NX5?
RE: Open NX6 simulation in NX5?
"Good to know you got shoes to wear when you find the floor." - Robert Hunter
RE: Open NX6 simulation in NX5?
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Open NX6 simulation in NX5?
"Good to know you got shoes to wear when you find the floor." - Robert Hunter
RE: Open NX6 simulation in NX5?
RE: Open NX6 simulation in NX5?
I'll just start to model in NX5 again then.
//Anders