NX 3d corner
NX 3d corner
(OP)
Just making the switch from Catia to NX7-Im looking for the equivalent function of the "3d Corner". I see a "cylindrical corner" but the results are never tangent to the two lines i need. So what I am doing is making the cyl. corner and then "bridge curve" and try to match it as best I can. But I need to be able to enter a radius value. Any suggestions?





RE: NX 3d corner
Note that I think I might have a something that's a bit better and if I get it to work, I'll upload a copy of that as well.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: NX 3d corner
For visualization, think of a highway with an overpass...the onramp is what im looking for.
RE: NX 3d corner
RE: NX 3d corner
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: NX 3d corner
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.