HELIX SPIRAL SHEETMETAL
HELIX SPIRAL SHEETMETAL
(OP)
Ok i"m new to the site so bare iwth me. Need a Helix spiral sheet metal .1875x2" that looks like the pic. I have tried a number of ways and failed. In this thread thread559-160215: Helix Sheetmetal spring they say to check out a web site but i can not get ot it it keeps saying operation timed out? But someone els goes on to say "that's a good point useing surfaces"? Can someone fill in the blanks for me and spell out what they are talking about. Or tell me a good way of doing it?
Thanks!
Daniel
Thanks!
Daniel






RE: HELIX SPIRAL SHEETMETAL
Deepak Gupta
SW2009 SP4.1
SW2007 SP5.0
MathCAD 14.0
RE: HELIX SPIRAL SHEETMETAL
RE: HELIX SPIRAL SHEETMETAL
I need to have a HELICAL rotor and a stator.. But the catch is i need the STATOR to have twice the pitch length but same minor diameter as the rotor... i am just unable to get a helical shape with two starts to it. Could anyone please help me out in this..
I have a picture attached to help better visualisation
RE: HELIX SPIRAL SHEETMETAL
Dan
www.eltronresearch.com
Dan's Blog
RE: HELIX SPIRAL SHEETMETAL