beam connection in workbench 12.1
beam connection in workbench 12.1
(OP)
Hi,
I created some beam elements into workbench. I want to edit these elements with an apdl command. Is it possible to named or group these elements.
In my postresults, I can read a list of beam elements, but I want to have a description for each one.
I want to read results for these elements, but if I don't have a description it's not easy to identify them.
thx
Simon
I created some beam elements into workbench. I want to edit these elements with an apdl command. Is it possible to named or group these elements.
In my postresults, I can read a list of beam elements, but I want to have a description for each one.
I want to read results for these elements, but if I don't have a description it's not easy to identify them.
thx
Simon





RE: beam connection in workbench 12.1
Use the named selection option in Workbench this will make a component and can be used in APDL.
regards