set up id symbol leader by default
set up id symbol leader by default
(OP)
Is there a way to set up the id-symbol leader by default with
a dot in nx6? I have tried but the dimension will get the dot,too - what never wanted . thx in ad
a dot in nx6? I have tried but the dimension will get the dot,too - what never wanted . thx in ad





RE: set up id symbol leader by default
RE: set up id symbol leader by default
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: set up id symbol leader by default
"Good to know you got shoes to wear when you find the floor." - Robert Hunter