What is the best way to get I-deas .SYM into NX6?
What is the best way to get I-deas .SYM into NX6?
(OP)
What is the best way to get I-deas .SYM on my native hard drive into NX6?
Right now I believe it is by using export/import .dxf files.
Side Note: Why is there no "All file types" when I File->Open?
This conversion from I-deas to NX6 is such a giant pain in the butt.
Thanks,
FR
Right now I believe it is by using export/import .dxf files.
Side Note: Why is there no "All file types" when I File->Open?
This conversion from I-deas to NX6 is such a giant pain in the butt.
Thanks,
FR





RE: What is the best way to get I-deas .SYM into NX6?
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: What is the best way to get I-deas .SYM into NX6?
RE: What is the best way to get I-deas .SYM into NX6?
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: What is the best way to get I-deas .SYM into NX6?
Does CCM = CMM?
I'm trying to get my drawing formats set up ahead of time as (File->New) templates. These templates require some "stamps" that we have in i-deas symbols. (For example electrostatic sensitivity picture of a hand with a line through it.)
Therefore it would be nice if I could migrate some I-deas .sym symbols without migrating the entire TDM.
I was planning on bugging GTAC anyway today... I'll post what I find out.
RE: What is the best way to get I-deas .SYM into NX6?
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.