BREAKING A VIEW ON DRAWING
BREAKING A VIEW ON DRAWING
(OP)
is there any way you can break a view and shorten it.
i have very long assembly so i have to scale it way down to fit on the border and it hard to tell what is going on.
thanks
i have very long assembly so i have to scale it way down to fit on the border and it hard to tell what is going on.
thanks





RE: BREAKING A VIEW ON DRAWING
RE: BREAKING A VIEW ON DRAWING
Peter Stockhausen
Senior Design Analyst (Checker)
Infotech Aerospace Services
www.infotechpr.net