2010 toolbox configuring-adding in part numbers for bom
2010 toolbox configuring-adding in part numbers for bom
(OP)
I've gone thru the tedius labor of adding the part numbers, thru the toolbox configurer. I've typed in each of my different screws part numbers, so that when the bill of materials is printed on an assembly drawing a person can just go and order the number, instead of decoding HX-shcs0.375-16x1.5x1.5-n. Now I go to make the bom on the drawing, and under part number I still get the configuration number printed in the part number column.
What am I doing wrong?
What am I doing wrong?






RE: 2010 toolbox configuring-adding in part numbers for bom
Eric