Disappearing edges when ballooning
Disappearing edges when ballooning
(OP)
Hi. I am balooning in nx3 and when it goes to rename the component, the edges of objects covered by that detail are disappearing when the part gets renamed. I know it is a setting because it was not doing this before....I just cant seem to find out what one it is.
Thanks in advance.
Thanks in advance.





RE: Disappearing edges when ballooning
File -> utilities -> part clean-up -> toggle all "on" -> apply
RE: Disappearing edges when ballooning
Edit -> View -> Update Views...
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.