NX6 open part display
NX6 open part display
(OP)
When I close a part file in NX6 I get the NX Tips display.
I believe there is a toggle someplace that allows another open part to be immediately displayed when one is closed, but I have no idea where that toggle is.
I do not mind getting the NX Tips display when there are no other open parts, but can someone tell me where the toggle is that will display another part?
I believe there is a toggle someplace that allows another open part to be immediately displayed when one is closed, but I have no idea where that toggle is.
I do not mind getting the NX Tips display when there are no other open parts, but can someone tell me where the toggle is that will display another part?





RE: NX6 open part display
RE: NX6 open part display
Change will take effect next time you start NX.
RE: NX6 open part display
RE: NX6 open part display
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.