NX6 - Picking an edge through solid
NX6 - Picking an edge through solid
(OP)
I cannot find the option to pick a edge through the model. Like for blending, in NX4.0, I could pick the edges through the model. In NX6.0, I have to rotate the model to pick.
Is there an option to turn this on, or has it been removed?
Thank you
Justin
Is there an option to turn this on, or has it been removed?
Thank you
Justin
Justin
Designer





RE: NX6 - Picking an edge through solid
"Good to know you got shoes to wear when you find the floor." - Robert Hunter
RE: NX6 - Picking an edge through solid
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: NX6 - Picking an edge through solid
Justin
Designer