Lofted Bend Sheet Metal Cone
Lofted Bend Sheet Metal Cone
(OP)
SW09 x64 Sp3.0
I searched here via Google, found the following relevant:
thread559-199521: Problem Converting Cone To Sheet Metal Part
I am having troubles trying to Flatten a cone built via the Lofted Bend method. My cone is a little more complicated as it has a, overlapping edge and Tab & Slot features... or at least that is what I am trying to accomplish. I get an error stating that one of my Flatten-<Freeform Bends> cannot be unbent.
The purpose for the model is to be able to get the flat pattern with the locations of the tab and slot for securing the open edge of the cone. I'm hoping that new tricks were devised for SW09?
I searched here via Google, found the following relevant:
thread559-199521: Problem Converting Cone To Sheet Metal Part
I am having troubles trying to Flatten a cone built via the Lofted Bend method. My cone is a little more complicated as it has a, overlapping edge and Tab & Slot features... or at least that is what I am trying to accomplish. I get an error stating that one of my Flatten-<Freeform Bends> cannot be unbent.
The purpose for the model is to be able to get the flat pattern with the locations of the tab and slot for securing the open edge of the cone. I'm hoping that new tricks were devised for SW09?
"Art without engineering is dreaming; Engineering without art is calculating."
Have you read FAQ731-376: Eng-Tips.com Forum Policies to make the best use of these Forums?






RE: Lofted Bend Sheet Metal Cone
RE: Lofted Bend Sheet Metal Cone
"Art without engineering is dreaming; Engineering without art is calculating."
Have you read FAQ731-376: Eng-Tips.com Forum Policies to make the best use of these Forums?
RE: Lofted Bend Sheet Metal Cone
Deepak Gupta
SW2009 SP4.1
SW2007 SP5.0
MathCAD 14.0
RE: Lofted Bend Sheet Metal Cone
"Art without engineering is dreaming; Engineering without art is calculating."
Have you read FAQ731-376: Eng-Tips.com Forum Policies to make the best use of these Forums?
RE: Lofted Bend Sheet Metal Cone
Jeff Mirisola, CSWP, Certified DriveWorks AE
CAD Administrator, Ultimate Survival Technologies
My Blog
RE: Lofted Bend Sheet Metal Cone
"Art without engineering is dreaming; Engineering without art is calculating."
Have you read FAQ731-376: Eng-Tips.com Forum Policies to make the best use of these Forums?