Left hand part slightly different than the right hand part
Left hand part slightly different than the right hand part
(OP)
I need to create left and right handed parts in NX 6. Like this: h ttp://www. eng-tips.c om/viewthr ead.cfm?qi d=243985&a mp;page=33 Except that in my case some of the features in the right hand part will not be mirrored or will be different in the left hand part. So I was thinking of doing an extracted body in the right hand part at the point in the part navigator where all the features are the same in the two parts above that point in the tree. Then waving that body into the LH part, mirroring it and proceeding to develop the features in the LH part that are different. Is there a better approach?





RE: Left hand part slightly different than the right hand part
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Left hand part slightly different than the right hand part
Best regards
Simon NX4.0.4.2 MP10 - TCEng 9.1.3.6.c - (NX6.0.3.6 MP2 native)
www.jcb.com
Life shouldn't be measured by the number of breaths you take, but by the number of times when it's taken away...