Splitting curves
Splitting curves
(OP)
Hello, I have many curves that intersect each other in several points and I need to split the curves at any intersection point. Is there a way to do this with just one command ?
Sandro Anderlini
Mould designer
Macerata - Italy





RE: Splitting curves
RE: Splitting curves
Sandro Anderlini
Mould designer
Macerata - Italy
RE: Splitting curves
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Splitting curves
Sandro Anderlini
Mould designer
Macerata - Italy
RE: Splitting curves
Best Regards
Hudson
www.jamb.com.au
Nil Desperandum illegitimi non carborundum
RE: Splitting curves
Sandro Anderlini
Mould designer
Macerata - Italy
RE: Splitting curves
That being said, alone Hudson's line, perhaps if you could explain better (in more detail) what exactly it is that you need to do that could not be done if the curve were left as they are.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.