Creating a common cutout sketch?
Creating a common cutout sketch?
(OP)
It seems like I'm always wanting to put an RJ45 type cutout or DB9 connector on some electrical device I have to draw up. Can you use the tool box to save these kind of sketches for later use or is there a better way?






RE: Creating a common cutout sketch?
-Dustin
Professional Engineer
Certified SolidWorks Professional
Certified COSMOSWorks Designer Specialist
Certified SolidWorks Advanced Sheet Metal Specialist
RE: Creating a common cutout sketch?
RE: Creating a common cutout sketch?
Dan
www.eltronresearch.com
Dan's Blog