Gap elements for contact simulations
Gap elements for contact simulations
(OP)
Hi,
I have to perform contact analysis between two parts as follows:
1) Pin (Male Part)
2) Socket (Female Part)
In order to do efficiently this simulation, I would like to use Nastran gap elements with sol 106.
Do you have any experience with this approach? If so, could you please refer me to some examples?
Thanks,
A.A.Y.
I have to perform contact analysis between two parts as follows:
1) Pin (Male Part)
2) Socket (Female Part)
In order to do efficiently this simulation, I would like to use Nastran gap elements with sol 106.
Do you have any experience with this approach? If so, could you please refer me to some examples?
Thanks,
A.A.Y.





RE: Gap elements for contact simulations
http://www
Onda
RE: Gap elements for contact simulations
Thank you very much for your reply. It is very helpful.
A.A.Y.