How to add a surface to sketched boat hull
How to add a surface to sketched boat hull
(OP)
I was wondering if anyone could point me in the right direction of how to cover the attached geometry with a surface. I'm very inexperienced with NX so any input would be appreciated.
Take care!
Take care!





RE: How to add a surface to sketched boat hull
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: How to add a surface to sketched boat hull
Best Regards
Hudson
www.jamb.com.au
Nil Desperandum illegitimi non carborundum