se st1
se st1
(OP)
Hi all
In SE ST1 i don't have control over variable after i create a part from sketch?
i see that in variable table user dimension
disappear after i create a part from sketch . is any other way to have control over variable ?
All the best
In SE ST1 i don't have control over variable after i create a part from sketch?
i see that in variable table user dimension
disappear after i create a part from sketch . is any other way to have control over variable ?
All the best





RE: se st1
RE: se st1
Synchronius mode of course in tradition mode i see all variables.
RE: se st1
RE: se st1
i think so. my question was why i can not change parts changing values in variable table. dimensions in variable table are inactive ( grey ) i can not change them.
i attached a picture maybe will be more expressive.
thank you
RE: se st1
In ST2 you have an option available if it's possible to change the value.
I'm sorry not to be of any more help.
Patrick
RE: se st1
i think is time to install se st2
all the best