designing a pull solenoid 3 lbs. pull
designing a pull solenoid 3 lbs. pull
(OP)
I am looking for a simple pull solenoid of about 1/2 to 5/8 " stroke
to be used on 120 V AC, but
12 V DC is also a possibility.
This solenoid needs to have approximately 3 lbs pulling power for the 1/2" stroke.
It would be nice if the solenoid could be working in a horizontal plane, but this is not a must.
What I don't know is what wire thickness would I need and how much current would I need ? And how may layers of windings and how long does the coil need to be.
How does amp relate to pulling power ?
Any ideas are most welcome................
Richard
to be used on 120 V AC, but
12 V DC is also a possibility.
This solenoid needs to have approximately 3 lbs pulling power for the 1/2" stroke.
It would be nice if the solenoid could be working in a horizontal plane, but this is not a must.
What I don't know is what wire thickness would I need and how much current would I need ? And how may layers of windings and how long does the coil need to be.
How does amp relate to pulling power ?
Any ideas are most welcome................
Richard





RE: designing a pull solenoid 3 lbs. pull
RE: designing a pull solenoid 3 lbs. pull
Keith Cress
kcress - http://www.flaminsystems.com