Cable Center Spline
Cable Center Spline
(OP)
I have a very complicated cable shape in Unigraphics NX5
The shape (solid body) is unparametric (imported from parasolid). Is there any way I can recreate the original center spline of cable ?
The shape (solid body) is unparametric (imported from parasolid). Is there any way I can recreate the original center spline of cable ?





RE: Cable Center Spline
Best Regards
Hudson
www.jamb.com.au
Nil Desperandum illegitimi non carborundum
RE: Cable Center Spline
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Cable Center Spline
RE: Cable Center Spline
Once the files are there, go to...
File -> Execute -> NX Open...
...and select the 'Cable_centerline1.dll' file and hit OK and then just do what the program prompts you to do.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Cable Center Spline
RE: Cable Center Spline
[b]File -> Execute -> NX Open...[/]
...just browse to wherever you placed them and select the .dll file.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.