Updating Hydraulic Model
Updating Hydraulic Model
(OP)
I have been tasked to update my company's hydraulic model developed by a consultant 2-3 years ago. does anyone know what softwares I will need to make this happen. All I have righ now is WaterCAD and Atlas GIS (we use in maintaining our system maps).
I would appreciate any suggestions or remaks on how or where to start.
I would appreciate any suggestions or remaks on how or where to start.





RE: Updating Hydraulic Model
RE: Updating Hydraulic Model
RE: Updating Hydraulic Model
RE: Updating Hydraulic Model
RE: Updating Hydraulic Model
I have done several models, each with over a 1,000 miles of watermains. However for each one, they were divided into numerous pressure zones. In general, each zone was a separate model. And perhaps you will want a separate model to handle the production and transmission mains, pumps, wells and tanks without including the thousand miles of distribution lines. Also, you may want to set a size limit so you are not modeling all the 2 inch lines along with the rest of the distribution system.