Controlling text size of ID symbols with Annotation editor
Controlling text size of ID symbols with Annotation editor
(OP)
When working with ID symbols on a drawing you often encounter that the text (with date) is to big for the ID symbol.
You can control the size of the text in the ID symbol by using the annotation editor like in the example attachment.
Hope this was usefull.
You can control the size of the text in the ID symbol by using the annotation editor like in the example attachment.
Hope this was usefull.
Best regards,
Michäël.
NX4.0.4.2 MP10 / TCE 9.1.3.8_build_0711 / NX6.0.2.8 / NX7.0.0.9
Belgium




