missing parts in lightweight
missing parts in lightweight
(OP)
Hi all,
When bouncing in and out of assemblies editing parts, I see these parts are missing when going back to the assembly. I believe it only happens in assembly lightweight mode and Solidworks may know about it already.
Has anyone else seen this in SW2009 sp3.0
When bouncing in and out of assemblies editing parts, I see these parts are missing when going back to the assembly. I believe it only happens in assembly lightweight mode and Solidworks may know about it already.
Has anyone else seen this in SW2009 sp3.0






RE: missing parts in lightweight
Deepak Gupta
SW2009 SP3.0
SW2007 SP5.0
MathCAD 14.0
RE: missing parts in lightweight