List Output unckecked by default
List Output unckecked by default
(OP)
Please have a look at the attached image.
Is it possible to set the default setting of list output in postprocess dialogbox as unchecked? If yes from where?
Postprocessing becomes very slow specially when posting 3D contour programs
Regards,
AK
Is it possible to set the default setting of list output in postprocess dialogbox as unchecked? If yes from where?
Postprocessing becomes very slow specially when posting 3D contour programs
Regards,
AK





RE: List Output unckecked by default
Using NX 3.0.5.3