Tap into a blind hole
Tap into a blind hole
(OP)
All,
Is there an option on the hole wizard to drill and tap for machined flat bottomed hole?
Rich.....
Is there an option on the hole wizard to drill and tap for machined flat bottomed hole?
Rich.....
Richard Nornhold, PE
http://www.ovenind.com






RE: Tap into a blind hole
Matt Lorono
CAD Engineer/ECN Analyst
Silicon Valley, CA
Lorono's SolidWorks Resources
Co-moderator of Solidworks Yahoo! Group
and Mechnical.Engineering Yahoo! Group
RE: Tap into a blind hole
The drilling and tapping depths can be controlled in the End Condition section.
RE: Tap into a blind hole
Best regards,
Chris Gervais
Application Engineer
CSWP, CSWST
RE: Tap into a blind hole
Deepak Gupta
SW2009 SP3.0
SW2007 SP5.0
MathCAD 14.0