Sketch Label
Sketch Label
(OP)
Is there a way to create a label in a sketch? i would like to point to a curve and say "this curve is for the upper surface".
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS Come Join Us!Are you an
Engineering professional? Join Eng-Tips Forums!
*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail. Posting GuidelinesJobs |
|
RE: Sketch Label
Of course, if you have the PMI module, you can do this right inside of Modeling by just adding a PMI Note to your already completed Sketch.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Sketch Label
RE: Sketch Label
Best regards
Simon NX4.0.4.2 MP10 - TCEng 9.1.3.6.c - (NX6.0.3.6 MP2 native)
www.jcb.com
Life shouldn't be measured by the number of breaths you take, but by the number of times when it's taken away...
RE: Sketch Label
Does this sound like a good ER?
John, do you ever originate ERs from what you read here?
RE: Sketch Label
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Sketch Label
Will the PMI functionality you're describing be included in the Mach 1 Design or Mach Advantage bundles?
RE: Sketch Label
NX12500 - NX MACH 2 Advanced FEM
NX13500 - NX MACH 3 NX Advanced Simulation
NX12430 - NX MACH 2 - Mill-Turn Machining
It can also be purchased as an add-on module.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.