Sketch in Drafting mode problem
Sketch in Drafting mode problem
(OP)
In Drafting (no views are present in the drawing), I created a sketch containing a line.
Then I created second sketch containing a circle. Now when I tried to create coincident constraint between centre of circle and end point of line of earlier sketch, the end point is not getting selected.
In modeling application, I am able to refer geometry of earlier sketch into another sketch, but in drafting I am not able to do so.
I am using NX4.0.4.2
Then I created second sketch containing a circle. Now when I tried to create coincident constraint between centre of circle and end point of line of earlier sketch, the end point is not getting selected.
In modeling application, I am able to refer geometry of earlier sketch into another sketch, but in drafting I am not able to do so.
I am using NX4.0.4.2





RE: Sketch in Drafting mode problem
So my advice is, just do all your work in a single Sketch.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.