Drafting Folded Radius
Drafting Folded Radius
(OP)
Hi All,
Is it possible to control the folded radius segments? please see the attachment, in that one folded radius (R1400)is constructed manually and the other one from NX5.0. I tried to move the first segment which starts from the center point of the arc but couldn't. Please share your views in this.
Thanks.
Is it possible to control the folded radius segments? please see the attachment, in that one folded radius (R1400)is constructed manually and the other one from NX5.0. I tried to move the first segment which starts from the center point of the arc but couldn't. Please share your views in this.
Thanks.
Raj
NX 5.0.6





RE: Drafting Folded Radius
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Drafting Folded Radius
I feel, it looks ugly if I use such a big folded segments for the radius. That is why I created manual dimension using lines.
Raj
NX 5.0.6
RE: Drafting Folded Radius
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.