Folded Centerline
Folded Centerline
(OP)
I was just wondering if the ability to add folded centerlines, similar to folded radii, has been added to NX?
Or would this be a good candidate for a ER?
Or would this be a good candidate for a ER?
"Good to know you got shoes to wear when you find the floor." - Robert Hunter





RE: Folded Centerline
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Folded Centerline
In my example the centerlines are model entities, and I used two identically oriented views to show them in the drawing, connecting the centerlines with lines on the face of the drawing.
"Good to know you got shoes to wear when you find the floor." - Robert Hunter
RE: Folded Centerline
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.