NX6 IGES, STEP Versions
NX6 IGES, STEP Versions
(OP)
I have been tasked with completing a customer questionaire regarding our CAD capabilities. All of it is straightforward except for determining what version level our IGES and STEP capabilities are. How do I determine what versions NX6 defaults to?
TIA!
TIA!
"Good to know you got shoes to wear when you find the floor." - Robert Hunter





RE: NX6 IGES, STEP Versions
I'm not sure if this is the IGES version for NX or if this is the version that the other software wrote out, but it may be a starting point.
RE: NX6 IGES, STEP Versions
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: NX6 IGES, STEP Versions
"Good to know you got shoes to wear when you find the floor." - Robert Hunter
RE: NX6 IGES, STEP Versions
Yes, the log files do list the spec that the translators comply with.
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
RE: NX6 IGES, STEP Versions
"Good to know you got shoes to wear when you find the floor." - Robert Hunter