NX4 error - "Part file is from a newer version of NX" when opening
NX4 error - "Part file is from a newer version of NX" when opening
(OP)
I haven't worked on a group of files in a year, but nothing has changed.
- my UG is the same (NX 4)
- I did not install any updates
- I did not work on these files on another computer
- I get the same error for ALL of my UG files
- I am using 400 Mb of memory out of 1,600 available
- I have the same UG setup on two different computers...same error on both computers.
When I try to open a file, the error I get is
"The following files could not be loaded causing this open to fail...Part file is from a newer version of NX than this one"
That is not true. I've always worked in NX4.
After I get this error and cancel out, then try to open a blank "New" file, I get the "memory access violation" error.
Any help?
Brian
- my UG is the same (NX 4)
- I did not install any updates
- I did not work on these files on another computer
- I get the same error for ALL of my UG files
- I am using 400 Mb of memory out of 1,600 available
- I have the same UG setup on two different computers...same error on both computers.
When I try to open a file, the error I get is
"The following files could not be loaded causing this open to fail...Part file is from a newer version of NX than this one"
That is not true. I've always worked in NX4.
After I get this error and cancel out, then try to open a blank "New" file, I get the "memory access violation" error.
Any help?
Brian





RE: NX4 error - "Part file is from a newer version of NX" when opening
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
RE: NX4 error - "Part file is from a newer version of NX" when opening
RE: NX4 error - "Part file is from a newer version of NX" when opening
RE: NX4 error - "Part file is from a newer version of NX" when opening
Tel : +1 800 955 0000
RE: NX4 error - "Part file is from a newer version of NX" when opening
It used to start up, but now it doesn't.
I've verified on a co-worker's desk that the files are not corrupt.
Any help?
Brian
RE: NX4 error - "Part file is from a newer version of NX" when opening
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.